Cisco BE6000S - Bridging Example
The following template was used on a Cisco 2921 - BE6KS platform. - The UCS chassis is installed in the router. - The router connects to the UCS chassis on interface ucse1/0 -> vmware nic0 and ucse1/1 -> vmware nic1 - Gi0/1 is connected to the distribution switch - VLAN 10 is the voice vlan - VLAN 1 is the data vlan and native vlan !---------------------------------------- !-- VLAN1 bridging !---------------------------------------- bridge irb ! ! bridge 1 protocol ieee bridge 1 route ip interface GigabitEthernet0/1 description ** Physical Uplink ** bridge-group 1 interface ucse1/0 description Internal interface connected to UCSE Port 0 ip unnumbered BVI1 service-module heartbeat-reset disable imc ip address 192.168.1.4 255.255.255.0 default-gateway 192.168.1.10 imc access-port shared-lom console bridge-group 1 interface BVI1 description Bridge interface providing access to router and UCSE module. ip address 192.168.1.6 255.255.255.0 ip ospf 1 area 0 !---------------------------------------- !-- VLAN 10 !---------------------------------------- bridge 10 protocol ieee bridge 10 route ip interface GigabitEthernet0/1.10 encapsulation dot1Q 10 bridge-group 10 interface ucse1/0.10 encapsulation dot1Q 10 ip unnumbered BVI10 bridge-group 10 interface BVI10 description ** VoIP ** ip address 10.10.10.1 255.255.255.0 ip ospf 1 area 0





Use this code to post the full script to your own page:



Use this code to post only the variables to your own page: